Mapping test results between TestArchitect and Team Foundation Server

This section describes possible test results mappings between TestArchitect and TFS when TestArchitect test results are uploaded into TFS.These are options that you set in the TEST MANAGEMENT window of TestArchitect’s Team Foundation Server external tool.

NoTA test statusTFS test status
1PassedPassed (default)Failed
Inconclusive

2FailedPassedFailed (default)
Inconclusive

3Passed with Warning/ErrorPassed
Failed (default)
Inconclusive

4Passed with Known BugPassed
Failed (default)
Inconclusive

5Not Finished 1Passed
Failed
Inconclusive (default)

6Not Run 2Passed
Failed
Inconclusive (default)

Important:

1 Not Finished occur if a test is started, but it is unable to reach the end of an automated run. An unfinished test case may result from any one of the following:

2 Not Run occurs when a test case is not even started.


Copyright © 2024 LogiGear Corporation. All rights reserved. LogiGear is a registered trademark, and Action Based Testing and TestArchitect are trademarks of LogiGear Corporation. All other trademarks contained herein are the property of their respective owners.

LogiGear Corporation

1730 S. Amphlett Blvd. Suite 200, San Mateo, CA 94402

Tel: +1 (650) 572-1400